Link ECU Plugin G4X EVO9 Mitsubishi with E-Throttle – 204-4000

Link ECU Plugin G4X EVO9 Mitsubishi with E-Throttle – 204-4000

Easy to install. Affordable. Reliable.
G4X PlugIn ECUs deliver the latest in engine management technology, designed to easily maximise the potential of your car.

This ECU fits directly inside the factory OEM enclosure. Installation is straightforward, with no alteration of the factory wiring loom required for the models listed below.

The EVO9X PlugIn ECU is designed specifically for the Mitsubishi Lancer Evolution 9 (4G63) engine.

Compatibility

Please ensure your connector matches the header shown in the product photo before purchasing.

Transmission: Manual only
MAP Sensor: Onboard 7 Bar
Factory Features: Most OEM functions are supported
Refer to the Features section for I/O expansion options.

Suitable Applications (204-4000 Automotive Computer Unit)

• CT9A Lancer Evolution 9 (2005–2007)

• CT9A Lancer Evolution 8 (2003–2005) with 3-plug ECU only

Any EVO 8 vehicle fitted with a 3-plug ECU will also require this ECU.

G4X PlugIn Key Features (where applicable)

Up to 6D fuel and ignition mapping
Precision closed loop cam control (four cam, independent control)
Sequential fuel delivery
Digital triggering, all OEM patterns
OEM idle hardware supported
5D boost control with three switchable tables
Motorsport features – antilag, launch, flat shift
Continuous barometric correction (on board)
CAN port
QuickTune – automated fuel tuning
Individual cylinder correction
USB tuning cable included
Stats recording into on-board memory
Gear compensations for spark, boost, and fuel
Real-time selectable dual fuel, ignition, and boost maps
Sync and crank sensors can be a combination of Hall effect, variable reluctance, or optical
Boost control referenced to gear, speed, or throttle position
512 megabytes of onboard data logging memory
Staged injection
Knock control with “windowing”

I/O Expansion Options

Expansion Connector 1
GND – Sensor ground only
+5V Out – Low current +5V supply
DI 9 – Digital input
DI 10 – Digital input
Aux 11 – Auxiliary output
An Volt 11 – Analog 0–5V input
An Volt 8 – Analog 0–5V input
An Temp 4 – Temperature sensor input

Expansion Connector 2
GND – Sensor ground only
+5V Out – Low current +5V supply
Aux 9 – E-Throttle (cannot be used as an Aux output)
Aux 10 – Auxiliary output
An Volt 6 – Analog 0–5V input
An Volt 7 – Analog 0–5V input
An Volt 9 – Analog 0–5V input
An Volt 10 – Analog 0–5V input